Still still still under? : r/FixMyPrint
I am getting random lines. : r/FixMyPrint
Under-extrusion next to seam. : r/FixMyPrint
Weird stringing on prints : r/FixMyPrint
Consistent issue with first layer + bed mesh : r/FixMyPrint
Top layer overextrusion? : r/FixMyPrint
What could cause banding mostly probounced on the Y axis on the print side? Again, it's just (mostly) on one side : r/FixMyPrint
For some reason my printer keeps skipping layers on the same spots on the Z axis. Sometimes they're not as noticeable/as bad but they still affect the print. The level at which
I am printing an xyz calibration cube on an ender 3 pro and there is a consistent indent and then bulge at the height shown in the picture. Any knowledge on why
All my prints have a bump about 1 inch up. What could be causing this? : r/ FixMyPrint
Consistent Print Failures on Dremel 3D40 : r/FixMyPrint